If you are planning to study Polymer Engineering at University of Lagos located in Lagos State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNILAG was established in 1962 by the Federal Government of Nigeria as one of the first-generation universities. It was created to promote higher education, research, and national integration. This page explains everything you need to know to increase your chances of gaining admission into UNILAG.
Does University of Lagos (UNILAG) offer Polymer Engineering?
No, University of Lagos does not offer Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Lagos (UNILAG) below to check if the Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer Engineering When Accredited in University of Lagos (UNILAG)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Polymer Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNILAG Cut-Off Mark for Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNILAG Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNILAG Science Courses with their Requirements
1. Physics
To study this course, candidates seeking admission into the Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
2. Education and Physics
To study this course, the minimum requirement for applicants seeking admission to the Education and Physics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
two (2) other Science subjects or NTC / NBC.
3. Microbiology
To study this course, candidates aspiring to gain admission into Microbiology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
4. Metallurgical and Material Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Metallurgical and Material Engineering department.
one other Science subject.
5. Geophysics
To study this course, candidates seeking admission into the Geophysics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Biochemistry
To study this course, candidates aspiring to gain admission into Biochemistry department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
7. Health Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Health Education department.
any two (2) other relevant subjects.
Nigerian Tertiary Institutions Offering Polymer Engineering Course