If you are planning to study Electrical and Computer Engineering at University of Nigeria, Nsukka located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNN was established in 1960 as a federal university located in Nsukka, Enugu State. It was founded as the first full-fledged indigenous university in Nigeria, aimed at promoting higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into UNN.
Does University of Nigeria, Nsukka (UNN) offer Electrical and Computer Engineering?
No, University of Nigeria, Nsukka does not offer Electrical and Computer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Nigeria, Nsukka (UNN) below to check if the Electrical and Computer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Electrical and Computer Engineering When Accredited in University of Nigeria, Nsukka (UNN)
O’Level Requirements
To study this course, candidates seeking admission into the Electrical and Computer Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any one other relevant subject.
UNN Cut-Off Mark for Electrical and Computer Engineering
The general UTME cut-off mark is 180, but due to the variation of Electrical and Computer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNN Science Courses with their Requirements
1. Medical Rehabilitation
To study this course, candidates aspiring to gain admission into Medical Rehabilitation department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
2. Geology
To study this course, the minimum requirement for applicants seeking admission to the Geology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
3. Agricultural Science and Education
To study this course, candidates aspiring to gain admission into Agricultural Science and Education department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Biology/Agricultural Science,
any other relevant subject.
4. Nursing (Science)
To study this course, candidates seeking admission into the Nursing (Science) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
5. Surveying and Geoinformatics
To study this course, candidates aspiring to gain admission into Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Joinery, Carpentry, Decorative Painting, Lining, Sign & Design, Wall Hanging, Colour Mixing / Matching & Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity,
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block Laying, Concreting, Wall, Floors and Ceiling Finishing.
6. Physics / Astrology
To study this course, the minimum requirement for applicants seeking admission to the Physics / Astrology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject from:
Biology or Agricultural Science.
7. Physical Education
To study this course, candidates seeking admission into the Physical Education department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Biology or its Equivalent,
any two (2) relevant subjects.
Nigerian Tertiary Institutions Offering Electrical and Computer Engineering Course