If you are planning to study Mechanical Metalwork Technology Education at University of Nigeria, Nsukka located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNN was established in 1960 as a federal university located in Nsukka, Enugu State. It was founded as the first full-fledged indigenous university in Nigeria, aimed at promoting higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into UNN.
Does University of Nigeria, Nsukka (UNN) offer Mechanical Metalwork Technology Education?
No, University of Nigeria, Nsukka does not offer Mechanical Metalwork Technology Education under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Nigeria, Nsukka (UNN) below to check if the Mechanical Metalwork Technology Education course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical Metalwork Technology Education When Accredited in University of Nigeria, Nsukka (UNN)
O’Level Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechanical Metalwork Technology Education department under Faculty of Engineering / Technology.
one (1) of Biology /Agricultural Science; Physics, or Chemistry and
two (2) from General Science/IntegratedScience, Technical Drawing/Fine Art, Health Science Food and Nutrition,
Geography, Physical and Health Education, Auto Technical, Building, Electrical Electronic, Metal Work and Wood Work.
JAMB Subject Combination
any other relevant subject.
UNN Cut-Off Mark for Mechanical Metalwork Technology Education
The general UTME cut-off mark is 180, but due to the variation of Mechanical Metalwork Technology Education cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNN Science Courses with their Requirements
1. Computer Science (CS)
To study this course, candidates aspiring to gain admission into Computer Science (CS) department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other Science subjects.
2. Mechanical Engineering
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Mechanical Engineering department.
any two (2) other relevant Science subjects.
3. Microbiology
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
4. Computer Education
To study this course, the minimum requirement for applicants seeking admission to the Computer Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
5. Zoology
To study this course, candidates aspiring to gain admission into Zoology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
6. Teacher Education Science
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Teacher Education Science department.
any two (2) other relevant subjects.
7. Industrial Technical Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Technical Education department.
Mathematics / Physics and
any other three (3) relevant subjects.
Nigerian Tertiary Institutions Offering Mechanical Metalwork Technology Education Course