If you are planning to study Mechatronics and System Engineering at University of Nigeria, Nsukka located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. This page explains everything you need to know to increase your chances of gaining admission into UNN.
Does University of Nigeria, Nsukka (UNN) offer Mechatronics and System Engineering?
No, University of Nigeria, Nsukka does not offer Mechatronics and System Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Nigeria, Nsukka (UNN) below to check if the Mechatronics and System Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics and System Engineering When Accredited in University of Nigeria, Nsukka (UNN)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Mechatronics and System Engineering department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject.
UNN Cut-Off Mark for Mechatronics and System Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNN Science Courses with their Requirements
Microbiology
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Microbiology department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Pure and Industrial Chemistry
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Pure and Industrial Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Architecture
SSCE Requirements
To study this course, candidates seeking admission into the Architecture department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
Metallurgical and Material Engineering
SSCE Requirements
To study this course, candidates aspiring to gain admission into Metallurgical and Material Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
one other Science subject.
Teacher Education Science
SSCE Requirements
To study this course, candidates aspiring to gain admission into Teacher Education Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
Industrial Technical Education
SSCE Requirements
To study this course, the minimum requirement for applicants seeking admission to the Industrial Technical Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Mathematics / Physics and
any other three (3) relevant subjects.
Geology
SSCE Requirements
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Geology department.
any other relevant subject.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course