If you are planning to study Polymer Engineering at University of Nigeria, Nsukka located in Enugu State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNN was established in 1960 as a federal university located in Nsukka, Enugu State. It was founded as the first full-fledged indigenous university in Nigeria, aimed at promoting higher education, research, and national development. This page explains everything you need to know to increase your chances of gaining admission into UNN.
Does University of Nigeria, Nsukka (UNN) offer Polymer Engineering?
No, University of Nigeria, Nsukka does not offer Polymer Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Nigeria, Nsukka (UNN) below to check if the Polymer Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Polymer Engineering When Accredited in University of Nigeria, Nsukka (UNN)
O’Level Requirements
To study this course, candidates seeking admission into the Polymer Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other Science subject.
UNN Cut-Off Mark for Polymer Engineering
The general UTME cut-off mark is 180, but due to the variation of Polymer Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNN Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNN Science Courses with their Requirements
1. Nursing (Science)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Nursing (Science) department.
2. Human Anatomy
To study this course, candidates aspiring to gain admission into Human Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Food Science and Technology (FT)
To study this course, candidates seeking admission into the Food Science and Technology (FT) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any two (2) other relevant subject from;
Biology / Agricultural Science, Physics, Basic Catering and Food Services, Bakery and Confectionaries,
4. Architecture
To study this course, candidates aspiring to gain admission into Architecture department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
5. Urban and Regional Planning (URP)
To study this course, candidates seeking admission into the Urban and Regional Planning (URP) department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Physics, Chemistry, Economics, Government, Biology, Art, History, IRK/CRK, Social Studies and Tech Drawing.
6. Civil Engineering
To study this course, candidates aspiring to gain admission into Civil Engineering department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
7. Agricultural Science and Education
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Science and Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science,
any other relevant subject.
Nigerian Tertiary Institutions Offering Polymer Engineering Course