If you are planning to study Environmental Biology and Fisheries at University of Uyo located in Akwa Ibom State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIUYO was established in 1975 by the Akwa Ibom State Government (then Cross River State) to provide higher education and promote research and development in southeastern Nigeria. This page explains everything you need to know to increase your chances of gaining admission into UNIUYO.
Does University of Uyo (UNIUYO) offer Environmental Biology and Fisheries?
No, University of Uyo does not offer Environmental Biology and Fisheries under its Faculty of Science. However, since our course list is updated regularly, you can visit the courses available at University of Uyo (UNIUYO) below to check if the Environmental Biology and Fisheries course under the Faculty of Science has been updated.
Admission Requirements for Environmental Biology and Fisheries When Accredited in University of Uyo (UNIUYO)
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Environmental Biology and Fisheries department under Faculty of Science, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Including two (2) other Science subjects
JAMB Subject Combination
Including two (2) other subjects (Physics, Chemistry, and Mathematics)
UNIUYO Cut-Off Mark for Environmental Biology and Fisheries
The general UTME cut-off mark is 180, but due to the variation of Environmental Biology and Fisheries cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIUYO Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIUYO Science Courses with their Requirements
1. Doctor of Pharmacy
To study this course, the minimum requirement for applicants seeking admission to the Doctor of Pharmacy department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
2. Building
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Building department.
Geography, Economics, Arts and Technical drawing.
For holders of NTC, the other relevant subjects could be;
Intro. to Building Construction, Bricklaying, Concreting, Walls, Floors and Ceiling Finishing, Building / Engineering Drawing, Joinery, Carpentry, Gas, Steam Work and Bronze Welding, Cold / Hot Water Supply, Sanitation and Drainage.
3. Fisheries and Aquatic Environment Management
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Fisheries and Aquatic Environment Management department.
Biology/Agricultural Science,
any other Science subject.
4. Statistics
To study this course, candidates aspiring to gain admission into Statistics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other relevant subject.
5. Land Surveying and Geoinformatics
To study this course, candidates aspiring to gain admission into Land Surveying and Geoinformatics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics,
Introduction to Building Construction, Bricklaying/Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design,
Wall Hanging, Colour Mixing/Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
6. Architecture
To study this course, the minimum requirement for applicants seeking admission to the Architecture department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics, Introduction to Building Construction, Bricklaying / Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design, Wall Hanging, Colour Mixing / Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, and Basic Electricity
7. Industrial Technology Education
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Industrial Technology Education department.
three (3) other relevant subjects.
Nigerian Tertiary Institutions Offering Environmental Biology and Fisheries Course