If you are planning to study Mechatronics and System Engineering at University of Uyo located in Akwa Ibom State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. UNIUYO was established in 1975 by the Akwa Ibom State Government (then Cross River State) to provide higher education and promote research and development in southeastern Nigeria. This page explains everything you need to know to increase your chances of gaining admission into UNIUYO.
Does University of Uyo (UNIUYO) offer Mechatronics and System Engineering?
No, University of Uyo does not offer Mechatronics and System Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at University of Uyo (UNIUYO) below to check if the Mechatronics and System Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechatronics and System Engineering When Accredited in University of Uyo (UNIUYO)
O’Level Requirements
To study this course, candidates aspiring to gain admission into Mechatronics and System Engineering department under Faculty of Engineering / Technology, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any other Science subject.
UNIUYO Cut-Off Mark for Mechatronics and System Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechatronics and System Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from UNIUYO Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other UNIUYO Science Courses with their Requirements
1. Education and Biology
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Education and Biology department.
2. Human Anatomy
To study this course, candidates aspiring to gain admission into Human Anatomy department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
3. Physics
To study this course, candidates seeking admission into the Physics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Chemistry, Mathematics and
any other Science subject from
Biology / Agricultural Science.
4. Agricultural Science and Education
To study this course, the minimum requirement for applicants seeking admission to the Agricultural Science and Education department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology/Agricultural Science,
any other relevant subject.
5. Land Surveying and Geoinformatics
To study this course, candidates seeking admission into the Land Surveying and Geoinformatics department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
Fine Art, Geography or Wood Work, Biology, Economics, Technical Drawing, Further Mathematics,
Introduction to Building Construction, Bricklaying/Block laying, Concreting, Wall,
Floors and Ceiling Finishing, Joinery, Carpentary, Decorative Painting, Lining, Sign and Design,
Wall Hanging, Colour Mixing/Matching and Glazing, Ceramics, Graphics Design, Graphic Printing, Basic Electricity.
6. Computer Science (CS)
To study this course, the minimum requirement for applicants seeking admission to the Computer Science (CS) department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any two (2) other Science subjects.
7. Statistics
To study this course, the minimum requirement for applicants seeking admission to the Statistics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other relevant subject.
Nigerian Tertiary Institutions Offering Mechatronics and System Engineering Course