If you are planning to study Mechanical and Metallurgical Engineering at Veritas University, Abuja located in Abia State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. VUNA was established in 2007 by the Catholic Church (Missionaries of the Divine Mercy) as a private university in Abuja to provide faith-based education with strong academic and moral values. This page explains everything you need to know to increase your chances of gaining admission into VUNA.
Does Veritas University, Abuja (VUNA) offer Mechanical and Metallurgical Engineering?
No, Veritas University, Abuja does not offer Mechanical and Metallurgical Engineering under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Veritas University, Abuja (VUNA) below to check if the Mechanical and Metallurgical Engineering course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Mechanical and Metallurgical Engineering When Accredited in Veritas University, Abuja (VUNA)
O’Level Requirements
To study this course, candidates seeking admission into the Mechanical and Metallurgical Engineering department under Faculty of Engineering / Technology, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
one (1) other Science subject.
VUNA Cut-Off Mark for Mechanical and Metallurgical Engineering
The general UTME cut-off mark is 180, but due to the variation of Mechanical and Metallurgical Engineering cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from VUNA Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other VUNA Science Courses with their Requirements
1. Microbiology
To study this course, candidates seeking admission into the Microbiology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
2. Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
3. Education and Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Education and Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology and Agricultural Science.
4. Computer Science (CS)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Computer Science (CS) department.
any two (2) other Science subjects.
5. Teacher Education Science
To study this course, candidates aspiring to gain admission into Teacher Education Science department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
any two (2) other relevant subjects.
6. Physics With Electronics
To study this course, the minimum requirement for applicants seeking admission to the Physics With Electronics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
any other Science subject from Further Mathematics and Biology / Agricultural Science.
7. Industrial Chemistry
To study this course, the minimum requirement for applicants seeking admission to the Industrial Chemistry department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology / Agricultural Science.
Nigerian Tertiary Institutions Offering Mechanical and Metallurgical Engineering Course