If you are planning to study Prosthesis and Orthopaedic Technology at Wesley University, Ondo formally known as Wesley University of Science and Technology (WUSTO) located in Ondo State, it is important to understand the admission requirements, cut-off mark, and career opportunities before applying. Wesley University, Ondo was established in 2008 by the Methodist Church of Nigeria as a private university in Ondo State to provide quality higher education grounded in Christian values and academic excellence. This page explains everything you need to know to increase your chances of gaining admission into Wesley University, Ondo.
Does Wesley University, Ondo offer Prosthesis and Orthopaedic Technology?
No, Wesley University, Ondo does not offer Prosthesis and Orthopaedic Technology under its Faculty of Engineering / Technology. However, since our course list is updated regularly, you can visit the courses available at Wesley University, Ondo below to check if the Prosthesis and Orthopaedic Technology course under the Faculty of Engineering / Technology has been updated.
Admission Requirements for Prosthesis and Orthopaedic Technology When Accredited in Wesley University, Ondo
O’Level Requirements
To study this course, the minimum requirement for applicants seeking admission to the Prosthesis and Orthopaedic Technology department under Faculty of Engineering / Technology, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Wesley University, Ondo Cut-Off Mark for Prosthesis and Orthopaedic Technology
The general UTME cut-off mark is 180, but due to the variation of Prosthesis and Orthopaedic Technology cut-off mark depending on the admission year and competition level, we suggest you enquire about the recent JAMB UTME cut-off mark from Wesley University, Ondo Officials. However, to improve your admission chances:
Perform well in Post-UTME screening.
Other Wesley University, Ondo Science Courses with their Requirements
1. Environmental Science and Technology
To study this course, candidates aspiring to gain admission into Environmental Science and Technology department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subject.
2. Electronics
To study this course, the minimum requirement for applicants seeking admission to the Electronics department, is five (5) credits (C5 and higher) in their SSCE subjects, including the following:
Biology or Agricultural Science.
3. Food Science and Technology (FT)
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Food Science and Technology (FT) department.
any two (2) other relevant subject from;
Biology / Agricultural Science, Physics, Basic Catering and Food Services, Bakery and Confectionaries,
4. Industrial Mathematics
To study this course, candidates aspiring to gain admission into Industrial Mathematics department, should at least obtain five (5) credit (C5 and above) passes in their SSCE subjects including:
two (2) other Science subjects.
5. Chemistry
To study this course, candidates seeking admission into the Chemistry department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
6. Geology
To study this course, candidates seeking admission into the Geology department, must have at least five (5) credits (C5 and more) in their SSCE disciplines, including the following:
any other relevant subject.
7. Biochemistry
To study this course, a minimum of five (5) credit passes (C5 and higher) in their SSCE subjects, including the following, are required for applicants to the Biochemistry department.
Nigerian Tertiary Institutions Offering Prosthesis and Orthopaedic Technology Course